Weld-On Tie Down Anchors

  • $27.97
    Unit price per 


Looking for a better option than wrapping synthetic straps or chains around you axle tubes to tie down you buggy/Jeep/truck? Well look no further!

Our brackets are CNC plasma cut and formed in-house, using USA made 1/4” HRPO plate.

The variations are as follows:

Hook-Style for tube- These brackets allow the use of pretty much any ratchet strap hook on the market, from safety hooks to bent-wire type hooks. The window on the bracket allows for 75-80* of side pulling ability before the safety hook itself is put into any side loads(hook manufacturer dependent on the allowable angle). The bent-wire type hooks will allow for more side-loading angle, but also lack the latch of the safety hooks. The radius of the bracket is a 3” diameter, with fattened ends to allow grinding to fit 3.25”, 3.5” and even 4” axle tubes. Each side of the bracket allows for 3 linear inches of weld, allowing for 6” total of linear weld per bracket. These brackets measure 2-5/8”" wide.

Hook-Style for Flat surfaces- Same characteristics as the Hook-Style for tube, but with a flat surface, intended for welding to the face of an axle truss. As with the previously mentioned brackets, each side of the bracket allows for 3 linear inches of weld, allowing for 6” total of linear weld per bracket. These brackets measure 2-5/8”" wide.

Chain-Style for Tube- Features the same 3” diameter mounting style of the Hook-Style for Tube, but with accommodations to fit 3/8” chain. These brackets sit slightly higher off the tube than the Hook-Style, to allow the chain to pass through the bracket and easily clear the axle tube behind it. As with the previously mentioned brackets, each side of the bracket allows for 3 linear inches of weld, allowing for 6” total of linear weld per bracket. These brackets measure 2-3/4”" wide.

Chain-Style for Flat-Same characteristics as the Chain-Style for tube, but with a flat surface, intended for welding to the face of an axle truss. As with the previously mentioned brackets, each side of the bracket allows for 3 linear inches of weld, allowing for 6” total of linear weld per bracket. These brackets measure 2-3/4”" wide.

 

***SOLD IN PAIRS***

***If you need a mix and match of mounting styles, send an email after you order, with your order # attached and specific needs***

 

***These are made-to-order, so please allow 3-5 business days for assembly, prior to shipping***